2008 DEWALT DW744X and DW744XC 10 inch Job Site Table Saw

IMPORTANT SAFETY RECALL
DEWALT DW744X and DW744XC – 10" Job Site Table Saw

It is possible for the pivot bracket to separate. This can cause mis-alignment between the blade and the fence, posing a kick-back hazard.
The following products are affected:

 Model Number  Description Date Code 
 DW744X  10" Job Site Table Saw
 
  2007 15 through 2007 40 

 
 DW744XC  10" Job Site Table Saw and DW367 7-1/4" Circular Saw     2007 15 through 2007 40 

ONLY TABLE SAWS WITH THE MODEL NUMBERS AND DATE CODES LISTED ABOVE ARE AFFECTED
 

The location of the model number and date code are shown on the photography below. Products stamped with an "X" following the date code are not affected.

The location of the model number and date code are shown on the photography below. Products stamped with an "X" following the date code are not affected.

If your table saw is affected, STOP USING IT IMMEDIATELY, and call DEWALT toll-free: 1-888-742-9178 between 8:00 AM – 5:00 PM Eastern Time Monday through Friday.

www.DEWALT.com

for the location of a service center to obtain a replacement table saw.
Recall done in cooperation with U.S. Consumer Product Safety Commission 04/08 DW744XRP
Post Until September 1, 2008